Skip to main content

FactoryMaster: Wrong Inspection report number is generating and being printed out

When I print an inspection report, an erroneous number is being sent as a parameter as well as the correct one, forcing the wrong report to be printed out.

S
Written by Sebastian Pavel Rus
Updated this week

There are two parameters sent are 'Inspection Type' and 'Inspection Number'. Valid template types are listed below:

  • 1 = WO inspection

  • 2= OP inspection

  • 3=In-Process inspection

  • 4=Batch Receipt Inspection

  • 5=Part Certification

  • 6=Tool Calibration

  • 7=FAIR

  • 8=WO Certification

  • 9=S/C Receipt Inspection

  • 10=Multi Job Processing


The Crystal Report therefore needs to be modified to accept two parameters (even if it is written in such a way that the 'Type' is not required).

Did this answer your question?